Komatsu — TIPS FOR LONGER UNDERCARRIAGE LIFE

. OPERATION OPERATION procedures, refer to "CHECK the idler guide plate and track inspection and adjustment IDLER CLEARANCE (PAGE 3 - 98 TIPS FOR LONGER UNDER Undercarriage life greatly varies d epending on operation method, inspection and mainte nance. For most efficien operation, keep the following point OPERATION METHOD uits the type of soil to be encountered in service. stributor when selecting track shoes. cur during operation. oad on the blade until slipping stops. n or stops, unnecessary high speeds and sharp turns. raight line whenever possible.

When making turns, be careful not to allow the Select the track shoe that best s Please consult your Komatsu di Do not allow shoe slipping to oc If shoe slipping occurs, reduce l Avoid sudden starts, acceleratio n or stops, unnecessary high speeds and sharp turns Always operate machine in a st raight line whenever possible. When making turns, b machine to stay to one side, so operation in both turning directions can be done properly. Make turns with the s and obstacles to prevent machine from riding over them while operating. parallel to the inclination of the slope. Also when stopping the ine should face the top of the left or right during digging dig with the incline.

Move the nd start to dig again. arry out work that exceeds its cludes cases where the idler or d when the machine meets f the machine during dozing or largest possible radius. Prior to operation, clear boulder s and obstacles to prevent machine from riding over th On a slope, operate the machine slope. Do not operate across the machine on a slope, the mach slope. When ground inclines to the operations, do not continue to machine back to level ground a Do not force the machine to c working capability. Such work in sprocket come off the groun obstacles that resist the power o ripping operations.

INSPECTION AND ADJUSTME Properly adjust the track tension The tension should be measure idler and carrier roller shown in t 30 mm (0.8 to 1.2 in) at this poin tracks slightly. In clay or sandy a inspection and adjustment pr TRACK SHOE TENSION, ADJ Check idler rollers for oil leakag nuts. If any trouble is detected, r Check clearance (B) between t frame. If clearance (B) increases the tracks may come off. (F procedure, refer to "ADJUST 4-34)".)