Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING 3 - 112 It is dangerous to charge a batte ry when mounted on a machine. Make sure that it is dismounted before charging. battery, stop the engine and turn the osition. When checking or handling the starting switch key to the OFF p The battery generates hydrogen gas, so there is a hazard of explosion. Do not bring lighted cigarettes n ear the battery, or do anything that will cause sparks. Battery electrolyte is dilute sulfu ric acid, and it will attack your clothes and skin. If it gets on your clothe s or on your skin, immediately wash it off with a large amount of water.

If it gets in your eyes, wash it out with fresh water and consult a doctor . ys wear safety glasses and rubber When handling batteries, alwa gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) termin al). When installing, install the positive (+) terminal first. If a tool touches the positive ter minal and the chassis, there is danger that it will cause a spark, so be e xtremely careful. If the terminals are loose, there i s danger that the defective contact may generate sparks that will cause an explosion. When removing or installing the terminals, check which is the positive (+) terminal and which is the neg ative (-) terminal.

REMOVE AND INSTALL BA TTERY 1. Open battery cover (1), rem remove cover (1). 2. Before removing battery, re connected to the negetive between the positive termin of sparks being generated. remove the wires from the 3. After installing the battery, f Tightening torque: 1.47 to 1 lbft) 4. When installing the battery, Insert the hole of the termina Tightening torque: 5.9 to 9. (0.6 to 1 5. Install battery cover (1). 1. Open battery cover (1), rem ove 4 bolts (2) on the inside, then move the ground cable (normally (-) terminal). If any tool touches al and the chassis, there is danger Loosen the nuts of the terminal and battery. ix it with the battery hold down. 3.

After installing the battery, f .96 Nm (0.15 to 0.2 kgm, 1.1 to 1.4 connect the ground cable last. 4. When installing the battery, l on the battery and tighten the nut. 8 Nm .0 kgm, 4.3 to 7.2 lbft) 5. Install battery cover (1).