Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE 4 - 28 REMARK If the cutting edge and the end bit on both sides are worn out, r eplace with new o nes If it ha s been worn out up to the fitting surf ace, repair the fitting surface and then reverse or replace. 4. Remove the cutti ng edge and the end bit and clean the mounting s urface. 5. Reverse or replac e the cutting edge and t he end bit when wor n ou 1) R emove nut ( 1) and bolt (2), then rep nd the end bit. ting edge on the blade lace or reverse the and tighten the bolt nst the ground to utting edge a 2) I nstall the cut emporarily. liminate the pecified torq Nut tightening torque: Powertilt dozer: 461 ± Powertilt , Power pitch dozer:

461 ± 69 Nm (47 ± 7 kgm , 340 ± 51 lbft. Semi-U dozer: 461 ± 69 Nm (47 ± 7 kgm , 34 Angledozer: 441 ± 49 Nm (45 ± 5 kgm , 325.5 If bo lt (2) and nut (1) are damaged, replace th em with new ones a t the same ti 6. After several hour s of running, retourque t