. MAINTENANCE SERVICE PROCEDURE supply CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING install oil level plug (2) and oil filler plug (1). 4 - 47 GREASE EQUALIZER BAR Left and right, 2 places each 1. Remove all dirt from the to p of the track frame and cover 2. Clean the grease fitting ind grease to that fitting with a REMARK Supply 3 shots of grease ( Operate the grease pump lever 3 times) to each grease fittin g, and check that grease is newly l lip. charged through the lip, continue ischarged. ewly discharged through the sea I f grease is not newly dis supplying grease until it is d GREASE EQUALIZER BAR CENTER PIN r on the left side of the chassis. (1 place) 1. 2. 1.
Open the engine side cove r on the left side of the chassis. 2. Clean the grease fitting ind icated with the arrow, then supply grease pump. grease to that fitting with a The oil is at high temperature im mediately after the machine has been operated. Wait for the oil to cool down before starting the operation. ng inside the case, the oil or plug may fly out. se the pressure. If there is still pressure remaini ng inside the case, the oil or plug may f Loosen the plug slowly to relea 1. Stop the machine so that dr ain plug (3) is directly at the bottom. 2. Remove oil level plug (2) and check whether the final drive er edge of the plug hole. drive case is filled with oil to low 3.
If the oil level is too low, add oil through the oil filler plug hole(1). 4. When oil starts to overflow f rom oil level plug (2), stop fillin g and