Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING with oil and install to the filter 4 - 57 EVERY 500 HOURS SERVI Maintenance for every 50 and 25 0 hours service should be carried The engine is at high temperature immediately after the machine has bee n operated. Wait for the en gine to cool down before replacing the filter. e fuel. Do not bring fire or sparks near th Prepare a filter wrench and a con 1. 2. 3. 1. Set the container under the fil oil. 2. Using a filter wrench, turn filt to remove it. 3. Clean the filter holder, fill the n then coat the packing surfac holder. NOTICE When filling with fuel, use clean fue dirt get in.

Portion (B) at the cente careful not to let any dust or dirt g When adding fuel, always add from dirty side. 4. When installing, tighten until t he packing surface contacts the r, then tighten it up 1/2 to 3/4 of ned too far, the packing will be to leakage of fuel. If the filter ll also leak from the packing, so amount. p (2) and operate it 50 to 60 times up and down. This will bleed the air. p (2) and tighten it. seal surface of the filter holde a turn. If the filter cartridge is tighte damaged and this will lead cartridge is too loose, fuel wi always tighten to the correct 5. Loosen the knob of feed pum p (2) and operate it 50 to 60 times up and down. This will 6.

Push in the knob of feed pum 7. After replacing the filter cartri dge, start the engine and check tha t there is no leakage of fuel from the filter seal surface. If there is any leakag e of fuel, check the tightening of th e filter cartridge. Whene ver there is leakage of fuel, follow Steps 1 and 2 to r emove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign mate rial is found in the packing, replace the packing with a new part, then repeat Steps 3 to 6 to install the filter cartri dge.