. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING engine is stopped and may cause serious burns. Wait for the oil holder, then tighten a 4 - 59 mmedia temperature to go do wn before performing this operation. Refill capacity: 3 Prepare a socke t wrench and filter wren 1. Remove the co ver on the bottom of th e machine and set a c ontainer to catch the draine drain plug. ug (P) (with a slit) slowly to avoid getting oil on ain the oil. ined oil, and if there are excessive metal eign material, please contact your Komatsu g (P).
ench, turn filter cartridge (1) counterclockwise tting oil on yourself, do not carry out this immediately under the cartridge. holder, fill the new filter cartridge with clean oil, and packing portion of the new filter cartridge thinly with grease), then install. the filter cartridge, bring the packing surface into contact with the filter turn. 2. Loosen drain pl ug (P) (with a slit) slow ly to avoid getting oil o yourself, and dr ain the oil. ined oil, and if there are excessive met eign material, please contact your Komats g (P). 3. Check the dra particles or for distributor. 4. Install drain plu 5. Using a filter wr ench, turn filter cartrid ge (1) counterclockwis on remove it.
tting oil on yourself, do not carry out thi immediately under the cartridge. To prevent ge arry operation from immediately under the cartridge. 6. Clean the filter holder, fill the new filter cartridge with clean oi coat the thread and packing portion of the new filter cartridg with oil (or coat thinly with grease), the n install. 7. When installing further 3/4 to 1 8. After replacing t he filter cartridge, add oil through oil f iller (F) until the oil level is between the dipstick (G) . 9. Run the engine at idle for a short time, then stop the engine, and check that the oil level L marks on the dipstick. For details, s ee "CHEC K OI L LEVE L IN ENGINE OIL PAN, AD