Komatsu — OPERATION

. ATTACHMENTS, OPTIONS HANDLING TOWING WINCH INCHING (BRAKE PARTIALLY APPLIED) WARNING This mode is used to move the vehicle forward without changing the position of the load hung on the wire rope. FLOAT (BRAKE RELEASED) WARNING speed and lower the load slowly. hand. 2. This operation enables the wire rope to be wound out under external force. REMARK Even when the lever is at the FLOAT (BRAKE RELEASED) position, the wire rope cannot be pulled by human force. 6 - 13 If the winch lever is pushed in to th e end, it is hitched at the brake releasing position (5). Since this is dangerous, do not p ush in the lever to the end. If it is hitched, 1.

When the winch control le ver is moved from the NEUTRAL position (N) towards positio is gradually reduced. Adjust match the weight of the load If the lever is pushed too fa load will drop. n (4), the braking force on the drum the position of the control lever to or the travel speed of the machine. r forward, there is danger that the 2. Release the winch lever, an d it will return to NEUTRAL position (N) automatically and the br operation. ake will be applied to stop inching When removing or installing the wire rope, always wear thick leather working Do not use the FLOAT position when lowering our load on a slope. The load will go down s uddenly.

Always wind out at low When winding out the wire rope under external force, do as follows er is moved fully forward from the atches in the notch and is held in his happens, the braking force on oved. To return the lever, pull it by