Komatsu — METHOD OF RELEASING PRESSURE IN OPERATING CIRCUIT ON MACHINE EQUIPPED WITH ACCUMULATOR

. ATTACHMENTS, OPTIONS HANDLING ACCUMULATOR HANDLING ACCUMULATOR WARNING the pressure in the control the work equipment to move WARNING operate the blade control 6 - 20 On ma chines equipped with an accumula tor, for a short time after the engine is stopped, if the blade c ontrol lever is moved to the LOWE R position, the work equipment wi ll move down under its own weight. the work equipment lock lever in the LOCK position. After stopping the engine, always place The a ccumulator is filled with high-press ure nitrogen gas, and it is extremely dangerous if it is handle d in the wrong way. Always obser ve the following precautions.

Ne ver make any hole in the accumula tor or expose it to flame or fire. ator. Do not weld any boss to the accumul Wh en disposing the accumulator, it i s necessary to release the gas from the accumulator, so ple ase contact your Komatsu dis tributor. The accumulator is a device to sto circui t, and when it is installed, the c for a short time even after the engin Therefore, if the control lever is mov work equipment, it is possible for t r its own weight. unde The a ccumulator is installed in the p on th e right.

METHOD OF RELEASING PRESSURE IN OPERATING CIRCUIT ON MAC WITH ACCUMULATOR Th e hydraulic system is always under internal pressure, so when inspecting or replacing the pipin g or hoses, always release the per pressure in the circuit before start ing. If the pressure is not released, high pressure oil may sp urt out and cause serious sonal injury. Wh en the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the pressur e before removing the cap. Ta ke note, however, that the remainin g internal pressure can hardly be released completely.

When d isconnecting the hydraulic cir cuit for the work equipment, theref ore, loosen the screw slowly and do not stand in the directio n that oil may spurt out. 1. S top the machine on firm level g 2. L ower the blade to the ground, t 3. T o release the internal pressur le a ver in each direction to the end fter stopping the engine. 4. L oosen oil filler cap (F) at the top re lease the internal pressure.