Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE Coolant density table WARNING the distilled water, see 1. Stop the machine in a horizontal place. 2. Stop the engine. 3. Check that the coolant temperature has gone down enough to make it possible to touch the radiator cap surface by hand, then turn radiator cap (1) slowly until it contacts the stopper to release the pressure. 4. Following this, push radiator cap (1), turn it until it contacts the stopper, then remove it. 5. Set a container in position to catch the coolant, then open drain valve (2) at the left side of the fuel tank. 6. After draining the water, close drain valve (2) and fill with city water. 7.

When the radiator is full, start the engine, and run it at low idle. Keep the engine running at low idle for 10 minutes until the coolant temperature reaches more than 90 ° C (194 ° F). 8. Stop the engine, open drain valve (2), drain the water, then tighten the drain valve again. 4 - 22 °C Ab Minimum Temp °F Ab ove -10 -15 -20 -25 -30 -35 - 40 -45 -50 ove 14 5 -4 -13 -22 -31 - 40 -49 -58 Concentration (%) 30 36 41 46 50 54 58 61 64 COOLANT is toxic. When open th e drain valve, be careful not to get coolant on you. eyes with large amount of fresh water and see a doctor at once.

If it gets in your eyes, flush your When changing the coolant or wh en handling the coolant containing COOLANT that has been drain ed during repair of radiator, please contact your Komatsu dist ributor or request a specialist company to carry out the operation . COOLANT is toxic. Do not let it flow into drainage ditches or spray it onto the ground surface. COOLANT is already diluted wi th distilled water, so it is not flammable. (For details of "COOLANT AND WATER FOR DILUTION (PAGE 4-5)"). Check the density with a COOL Prepare a container whose capa city is larger than the specified coolant volume to catch d Prepare a hose to use when fillin g with coolant. 9.

After draining the water, clea n the cooling system with cleaning agent. e the instructions for the cleaning agent. For the cleaning method, se 10. Add coolant through the wat er filler port up to the mouth of the port. For details of the COOLANT density, see "COOLANT DENSITY TABL E". 11. To bleed the air from the coo ling system, run the engine at low idle for 5 minutes, and f or a further 5 minutes at high idle. (When doing this, l eave the radiator cap off.)