. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE breather, then remove breather (3), soak it in flushing fluid, and wash it. After removing the breather, take steps to prevent dirt or dust from entering the mount. (1) Center hinge pin (2 places) 4 - 56 11. Refill the specifie d quantity o f oil through oil fille r (F). 12. After filli ng with oi l, check tha t the oil is a t the s pecified level. For deta ils, see " ANSMISSIO LEVEL, OIL (PA GE 4-24) hat there 13. Check t case or CLEAN TRANSMISSION CASE BREATHER 1. Loosen bolt (1) an d remove c over (2). 2. Remove all dirt and mud f rom around LUBRICAT 1.
Using a grease p ump, pump in grease th rough t he grease fittings marked by the arr 2. After gre asing, wi pe off any o ld grease th at was pushed out. (2) Drive sh aft center support (1