ce t — High Speed Travel

HYDRAULICS – CX130/CX160 TRAVEL High Speed Travel 1) The travel-speed solenoid is energized and the swash plate angle of a travel motor is shifted to minimum angle, high-speed travel occurs. The monitor display will indicate high-speed (Hi) . 2) The travel motors will switch to low-speed automatically at approximately 4200 psi and switch back to high-speed when the travel pressure is reduced. The monitor display does not change. Note: The controller needs a RPM signal and the Travel pressure switch for High-Speed travel. High-speed travel occurs when the operator selects high-speed with the travel switch on the control panel. The travel switch sends an electrical signal to the controller.

The controller will send a 24v signal to energize the travel-speed solenoid. When the valve is shifted, pilot pressure (550/600 psi) is directed from the solenoid valve to the travel motors. The pilot pressure shifts the 2-speed spool, which directs supply oil to shift the swash plate to minimum angle. The travel motors will shift to low-speed when the supply pressure reaches approximately 4200 psi. A pilot signal from the supply pressure inside the drive motors is routed to the 2-speed spool to shift it to the low-speed position. When the supply pressure is reduced the drive motors will shift back to high-speed.

The controller will turn off the high speed solenoid if the travel pressure drops below 580 psi to slow down travel going down a steep grade. The travel speed solenoid valve is located in the six-solenoid valve bank. The six-solenoid valve is located in the pump compartment. Travel Speed Solenoid Red Wire Band Pilot Pressure Solenoid 5 - 8 CX EXCAVATORS