HYDRAULICS – CX130/CX160 SWING Swing Operation 1) The swing holding brake prevents the upper structure from drifting on a hillside until the swing hand control is moved or either main pump pressure is raised to +2050 psi. 2) Pilot oil from the swing brake solenoid valve releases the swing brake. 3) The machine uses flow from one pump during swing operation. 4) The upper structure is braked hydraulically before the swing holding brake is applied. Swing, Brake off Operation When the swing hand control is operated, pilot pressure is directed to the swing control spool in the main control valve. The control spool shifts and sends pump2 oil to the swing motor for left or right swing.
At the same time a pressure switch in the swing pilot circuit is closed. The pressure switch sends a signal to the controller which turns OFF the swing-brake solenoid valve, the valve shifts and sends full pilot pressure (550/600 psi) to the swing brake to release the brake. The swing pressure switch is located in the swing shuttle valve mounted behind the cab. The swing brake solenoid is part of the six-solenoid valve located in the pump compartment. When ever either main pump pressure reaches approximately 2050 psi the controller will release the swing brake by turning OFF the swing-brake solenoid. This is done to protect the upper structure from side loading that occurs while digging.
The controller monitors pump pressure by way of pressure transducers located at each main pump. Swing Braking Operation When the swing control is returned to neutral, the centering springs of the swing control spool shift the spool to neutral. The oil flow from pump2 (rear pump) to the swing motor is diverted and the supply and return ports of the swing motor are blocked. The inertia from the swing movement will cause a pressure spike in the blocked return side of the motor. To prevent spike pressure damage, a built-in crossover relief valve is opened and oil flows through a make-up check valve to the supply side of the motor or to the reservoir.
When the pressure is equalized between the return and supply ports the motor acts as a brake and swing motion is stopped. Between the time the supply and return ports are blocked by the control spool and the crossover relief opens, oil from the main return circuit is available at port Mu of the swing motor to pass through the make-up check valve to the supply side of the motor. Five seconds after the swing lever is returned to neutral (swing pressure switch opens), the swing brake is applied when the controller sends an (24v) signal to energize the swing brake solenoid. The valve shifts and dumps the brake release pressure back to tank. The brake is spring applied and hydraulically released.
5 - 16 CX EXCAVATORS