ce t — High Speed Travel

HYDRAULICS – CX210/CX240 TRAVEL High Speed Travel 1) The Travel Speed solenoid is energized and the swash plate angle of the travel motors is shifted to minimum angle, high-speed travel occurs. The monitor display will indicate high speed (HI). 2) The travel motors will switch to low-speed automatically when the travel pressure reaches approximately 4200 psi and switches back to high-speed when the travel pressure is reduced. The monitor display does not change. Note: The controller needs the travel pressure switch and an input signal from the engine controller for high-speed travel. High-speed travel occurs when the operator selects high-speed with the travel switch on the control panel.

The travel switch sends an electrical signal to the controller. A 24v signal is sent by the controller to the travel-speed solenoid valve. When the valve is shifted, pilot pressure (550/600 psi) is sent to the travel motors. The pilot pressure shifts the 2-speed spool, which directs supply oil to shift the swash plate to minimum angle. The travel motors will shift automatically to low-speed when the supply pressure reaches approximately 4200 psi. A pilot signal from the supply pressure inside the drive motors is routed to the 2-speed spool to shift it to the low-speed position. When the supply pressure is reduced the drive motors will shift back to high-speed.

The controller will turn off the high speed solenoid if the travel pressure drops below 580 psi to slow down travel going down a steep grade. The travel speed solenoid valve is located in the six-solenoid valve bank. The six-solenoid valve is located in the pump compartment. Travel Speed Solenoid Red Wire Band Pilot Pressure Solenoid Blue Wire Band 6 - 8 CX EXCAVATORS