PRESSURE TESTING 7 - 2 CX EXCAVATORS CX130 PRESSURE TESTING PRESSURE SPECIFICATIONS Name: PIN # Condition CX130 Work mode S : Standard Mode Hydraulic oil temperature 45 ~ 55 ° C 113 ~ 131 °F Full Throttle No-load engine revolutions in: H Mode 2150 r.p.m.
(H Mode) Part Name Set Measuring Reading Pressure Method Main Relief STANDARD 4970 ± 45 psi Arm Circuit * P1 or P2 POWER BOOST 5260 ± 45 psi Arm Circuit and Power Boost button * P1 or P2 Boom Circuit Relief UP ✸ 5555 ± 70 psi Boom Up Circuit * P1 DOWN ✸ 4265 ± 70 psi Boom Down Circuit * P1 Bucket Circuit Relief OUT IN ✸ 5555 ± 70 psi Bucket Circuit * P1 Arm Circuit Relief OPEN CLOSE ✸ 5555 ± 70 psi Arm Circuit * P2 Swing Motor Crossover Relief LEFT RIGHT 4050 ± 70 psi Swing Motor Crossover * P2 Travel Crossover Relief LEFT ✸ 6235 ± 70 PSI Travel Crossover P1 & P2 RIGHT Pilot Circuit 570 ± 45 psi Pilot Test Port * P3 OTE: Circuit pressures are listed for reference only.
Listed values are low flow settings and not accurate when high flows are applied. However if adjusting secondary relief becomes ssary for service. Over set the main relief and run the engine at very low rpm’s. less than half tle.