ce t — FUEL SYSTEM FUNCTION

CX210/CX240 ELECTRONIC FUEL SYSTEM FUEL SYSTEM FUNCTION Fuel from the injection pump is sent to the injectors through high pressure injection lines in accordance with the engines firing order. The high pressure lines are connected to the distributor housing fittings at the pump and at fuel connectors at the cylinder head. The connectors direct the fuel through edge filters and on to the injectors. Fuel pressure builds in the injector until pressure under the needle becomes greater than the injector spring pressure allowing the needle to raise. Small spray holes in the injector tip allows fuel to exit the injector.

Leakage from the injector passes through a rifled passage drilled through the length of the cylinder head and joins the return flow of fuel. Pump timing is altered by changing the position of the cam ring in the injection pump. Timing is controlled by the master piston in the timing advance mechanism. During the cranking cycle the return spring holds the master piston and cam ring in the retarded position. This causes injection to occur at approximately top dead center. Transfer pressure is delivered to the master piston control valve and servo.

As engine speed increases, transfer pressure increases causing the master piston to move, compressing the return spring, causing the cam ring to rotate and causing injection to occur earlier. The pulsing timing control valve, activated by the ECM, can retard timing when energized, by venting pressure from the advance mechanism and allowing the return spring to move the master piston in the retard direction. This feature permits changes in timing up to 30 engine degrees. The calculated timing of the Engine ECM is sent to the FPCM where it is controlled. An Incremental Angle Timing (IAT) ring in the injection pump determines the beginning and end of injection.

Timing information from the IAT is compared to the timing information from the ECM for accuracy. If a variation of 3 degrees or more occurs, the FPCM data is retained however, the engine will operate at a reduced output (limp home mode). The Bosch VP44 injection pump is fixed position mounted and cannot be rotated to alter timing. Static pump timing for a specific application is obtained through the use of the proper drive shaft key. Keys are offset as required by the timing requirements, based on pump manufacturers tolerances. Keys are identified by a two digit part number on the top of the key along with an arrow which points toward the injection pump.

The required key part number can be found on the injection pump identification plate. 8 - 10 CX EXCAVATORS