CX210/CX240 ELECTRONIC FUEL SYSTEM 8 - 19 CX EXCAVATORS FAULT CODE LISTING Fault Associated Hardware Reason Effect (only with active code) F111 Electronic Control Module ECM internal hardware error Possible no effect, rough running engine or no start. F115 Crankshaft position sensor No speed or position signal at pin 17 of engine harness Engine power de-rate with possible white smoke F122 Boost pressure sensor high High voltage at pin 45 of engine harness. Engine will de-rate to no boost fueling. F123 Boost pressure sensor low Low voltage at pin 45 of engine harness.
Engine will de-rate to no boost fueling F131 Accelerator pedal positioning sensor High voltage at pin 30 of OEM connector Engine idles when idle validation switch indicates idle and ramps up to a default speed when validation is off idle. F132 Accelerator pedal positioning sensor Low voltage at pin 30 of OEM connector Same as above. F135 Engine oil pressure sensor high High voltage at pin 33 of engine harness Default value used. No engine protection for oil pressure F141 Engine oil pressure sensor low Low voltage at pin 33 of engine harness Default value used.
No engine protection for oil pressure F143 Oil pressure low Pressure measured below minimum protection limits Power de-rate and possible shut-down. F144 Coolant temperature sensor high High voltage at pin 23 of engine harness Default value used. No protection for coolant temp. F145 Coolant temp. sensor low Low voltage at pin 23 of engine harness Default value used. No protection for coolant temp. F146 Coolant temp. sensor/ EPF Coolant temp. has exceeded minimum protection limits. Power de-rate, possible engine shut-down