CONTROLLER PAST OVER LOAD CONDITION CHK5 R: Engine Load Ratio (CX210/CX240) FT: Fuel Temperature (CX210/CX240) TV: Throttle Volume TR1: Transistor output has detected an over current TR2: Transistor output has detected an over current TR3: Transistor output has detected an over current TR4: Not Used While in the CHK2 screen, press and hold the Travel mode switch this will allow you to view CHK5. CHK5 screen allows you to view PAST output conditions if an over current was detected. DO NOT HOLD SWITCH LONGER THAN 10 SECONDS. TRAVEL ALRM WILL SOUND. KEY WILL HAVE TO BE TURNED OFF TO TURN OFF ALARM. Note: To erase fault codes in CHK5 switch to DIAG5 and press the Work mode switch for 10 seconds.
The warning buzzer will sound. Turn OFF the key switch to complete the process. 3 - 26 CX EXCAVATORS CHK MODE 2 H 5 TR1 0 0 0 0 R 0 0 0 0 % TR2 0 0 0 0 FT 0 0 0 0 F TR3 0 0 0 0 TV 0 0 0 0 % TR4 0 0 0 0