ce t — CX210/CX240

CONTROLLER RESETTING Engine Speed for Hammer Mode RST MODE Hi, H 1 RPM RPM SEC Push the Buzzer stop switch to select BRK (item selected will have a light background). CX130/CX160 To set engine speed for hammer mode, start the engine and adjust RPM with the throttle control. Monitor will show actual RPM. Press the Work mode switch for 10 seconds to select the displayed RPM. The buzzer will sound to notify that 10 seconds have elapsed. CX210/CX240 Start the engine and adjust engine speed to desired RPM using the Free Swing switch to increase RPM and the Cushion switch to decrease RPM. The switches must be held for 5 seconds for a RPM change to occur.

Press and hold the work mode switch for 10 seconds. The alarm buzzer will sound. Turn the key switch off while running at desired RPM to complete the procedure. To confirm, start the engine, turn up the RPM, access CHK1 and observe the RPM when the hammer circuit is activated. 3 - 49 CX EXCAVATORS PA 0 0 0 0 BRK 0 0 0 0 AU 0 0 0 0 L/M Not Used HLD 0 0 0 0 AI 0 0 0 0 OUT Not Used