28 ENGINE SYSTEMS Fuel Injectors Fuel injector features Two 48 volt 20 amp coils control a spool valve that directs oil flow in and out of the injector. The injector coils are turned on for approximately 800 (micro second or millionth of a second). Each injector has a single four pin connector that passes through the rocker arm carrier Injector coils and spool valve An OPEN coil and a CLOSE coil on the injector move the spool from side to side using magnetic force. The spool has two positions: When the spool valve is open oil flows into the injector from the high pressure oil rail. When the spool valve is closed oil drains back to the crankcase.
Intensifier piston When the spool valve is open, high pressure oil enters the injector, pushing down the intensifier piston and plunger. Since the intensifier piston is 7.1 times greater in surface area than the plunger, the injection pressure is also 7.1 times greater than ICP pressure on the plunger. Fuel pressure builds between the plunger and the barrel. When the intensifier piston pushes the plunger down, the plunger increases fuel pressure in the barrel 7.1 times greater than ICP. The plunger has tungsten carbide coating to reduce scuffing and poor performance. Plunger and barrel Figure 24 Fuel Injector 1. CLOSE coil 2. Control valve body 3. Intensifier piston 4. Piston return spring 5.
Plunger 6. Valve opening pressure spring 7. Needle 8. OPEN coil 9. Spool valve (control valve) 10. Casenut 11. Fuel strainer (3) 12. Nozzle assembly Injector needle The injector needle opens inward, off its seat when fuel pressure overcomes the Valve Opening Pressure (VOP) - approximately 21 MPa (3100 psi). Fuel is atomized at high pressure through the nozzle tip. EGES295-2 Read all safety instructions in the "Safety Information" section of this manual before doing any procedures. Follow all warnings, cautions, and notes. ©2006 International Truck and Engine Corporation