ENGINE SYSTEMS 35 The oil filter base directs filtered oil in four ways: One passage supplies filtered oil to the oil temperature sensor, oil pressure sensor, oil supply tube for the VGT, and oil supply for the air compressor (optional). Figure 30 Oil reservoir in crankcase 1. Oil feed to high pressure pump 2. Oil filter drain to pan 3. Oil feed to oil cooler cover 4. Oil feed to left side of main lube oil gallery 5. Oil feed to right side of main lube oil gallery 6. Coolant feed to oil cooler Figure 29 Oil cooler base and oil filter base 1. VGT oil supply tube assembly 2. Oil filter housing 3. Oil filter base assembly 4.
Oil cooler cover A second passage supplies filtered oil to the reservoir in the crankcase for the high pressure pump and ICP system. Two other passages supply filtered oil for the following: Lube oil is routed from the front of the oil cooler cover to the back where it enters the oil cooler. Lube oil is cooled as it flows from the back of the oil cooler to the front into the oil filter housing. Left side Main lube oil gallery If the oil cooler is restricted, a bypass valve in the oil filter base will open and allow oil to bypass the oil cooler going directly to the oil filter housing. Push rod and rocker arms Piston cooling tubes Oil flows to the oil filter element.
Oil passes through the outside of the element to the inside of the element, down the stand pipe, back into the oil filter base, and into the oil cooler base. Right Side Main lube oil gallery Push rod and rocker arms Piston cooling tubes EGES295-2 Read all safety instructions in the "Safety Information" section of this manual before doing any procedures. Follow all warnings, cautions, and notes. ©2006 International Truck and Engine Corporation