INTRODUCTION SECTION 1 Page 3 1.1. INTRODUCTION Fig. 1.1. TD-40 Series C Crawler Tractor Equipped with Bulldozer Blade and Cab ! – Right Hand Side of the Machine " – Left Hand Side of the Machine # – Front of the Machine – Rear of the Machine General Throughout this manual there will be two types of cross-references. One type is to a heading in another section. The other is to a heading within the same section. Unless it is otherwise stated, references will be to the same section. Refer to the section contents page at the beginning of the individual sections for specific page numbers.
Some illustrations are of general application of this model and may not show your machine accurately in all details. Throughout this manual the use of the terms “left”, “right”, “front”, and “rear” must be understood to avoid confusion when following instructions. “Left" and “right" indicate the left and right sides of the machine when facing forward in the operator's seat. See Fig. 1.1. 1.2. SERIAL NUMBERS The product identification number (P.I.N.) is stamped on a plate attached to the front wall of the control console at the left hand side of the operator’s seat (Fig. 1.2). It is also stamped on the rear face of the rear frame in the upper right hand corner (Fig. 1.3).
The bulldozer model designation is stamped on the back of the blade, near the top right hand corner (Fig. 1.4). All other components having serial numbers are each equipped with a separate serial number plate. Use serial numbers when requesting information or ordering parts and proper numbers from Parts Catalogue. DRESSTA TD-40C