SECTION 5 MAINTENANCE Page 22 5.8. COOLING SYSTEM General The cooling system operates under pressure. The water pump circulates the coolant through the oil cooler, engine block, cylinder heads, and radiator. Circulation is controlled by the thermostats, which prevent coolant flow through the radiator until the engine reaches operating temperature. Proper cooling is as assured only when the system is sealed, radiator cap and gasket in good condition, thermostats operate properly, system is free of coolant and/or air floor restrictions and is filled to proper level. Selection and maintenance of the system coolant is important to long engine life.
The following information provides recommendations for selecting the engine coolant, maintaining the coolant inhibitors, and servicing the cooling system. This system will operate with a water/antifreeze mixture or inhibited water as a coolant. Never use water alone because water will allow rust, scale deposits, and corrosion to occur within the system. 5.8.1. WATER Use water, which has a low mineral content. Water used in conjunction with antifreeze, coolant filters and inhibited water must meet the following standards: Total hardness: Not to exceed 170 parts per million to prevent scale deposits.
Water containing dissolved magnesium and calcium (the usual reason for water hardness) above the specified amount will cause scale deposits to develop in the engine. Chlorides – Not to exceed 40 parts per million to prevent corrosion. Sulfites – Not to exceed 100 parts per million to prevent corrosion. Dissolved solids – Not to exceed 340 parts per million to minimize sludge deposits, scale deposits and corrosion. If any of the requirements cannot be met, use distilled de-ionized or de-mineralized water. To determine if local water supplies meet these standards, water treatment laboratories can test water samples.
Softened water that is prepared using common salt (sodium chloride) contains excessive amounts of chlorides and should not be used. 5.8.2. ANTIFREEZE Low silicate ethylene glycol antifreeze is recommended. The antifreeze should contain no more that 0.1% anhydrous alkali metasilicate. Low silicate antifreeze is recommended to avoid the formation of silica gel (hydro-gel). This gel formation can occur when cooling system contains an over concentration of high silicate antifreeze and/or supplemental coolant additive. DO NOT use methanol or alcohol as antifreeze because of its low boiling point.
Antifreeze may retain its freeze protection for more than one season but coolant conditioners must be added to maintain corrosion protection. Antifreeze formulated with metoxy propanol, or propylene glycol is not recommended for this system. IMPORTANT: Do not mix types of antifreeze solutions. Mixed solutions make it impossible to determine the protection against freezing. Antifreeze containing sealer or anti-leak additives should not be used in this system. Sealer or anti-leak additives will plug the coolant filter and cause plugging problems in the cooling system. TD-40C DRESSTA