SECTION 6 SPECIFICATIONS Page 4 TECHNICAL DESCRIPTION Drive train: Drive train includes the following components: Engine with Radiator Torque Converter U-Joint Transmission Pinion/Bevel Gear Set and Steering Drive Final Drives Engine power is transmitted through torque converter, U-joint, transmission, pinion /bevel gear set and steering drive to two final drives with mounted sprockets. Three-speed powershift transmission combined with two-speed steering gives 6 speeds forward and 6 speeds reverse. Steering is accomplished by application of clutch packs in steering drive.
Drive train is equipped with automatic system of speed control for FORWARD – REVERSE directional changes to protect the drive train against dynamic overload. Transmission system Transmission system includes oil tank which is rear frame, 10 µ suction filter of torque converter mounted pump, main regulator valve, rate of rise valve, range selector valve and transmission and steering drive control valves. Mounted equipment Semi-U Blade Full-U Blade Single-Shank and Multi-Shank Ripper Drawbar Blade lift and lower movements are accomplished with two blade lift cylinders. Blade tilt to the right and left is accomplished with one tilt cylinder.
Multi-shank ripper – 3 shanks, tool beam raised and lowered with hydraulic cylinder, ripper shanks are equipped with hydraulic pitch and can be adjusted in two vertical positions. Single-shank ripper is equipped with hydraulic pin puller. Fixed drawbar with vertical pin. Equipment hydraulic system Equipment hydraulic system consists of hydraulic reservoir with sight gauge and breather, suction filter, hydraulic pump, pilot control valve, control valve with pressure relief valve supplying hydraulic cylinders and return filters. Hydraulic cylinder operating pressure is 15.5 [Mpa]. TD-40C DRESSTA