SECTION 4 OPERATING Page 16 CONTROLS AND ADJUSTMENT This pedal overrides the engine speed control lever setting. Partial depression of the pedal decreases engine speed for smoother changes in machine direction and to ease the machine up to a load. Release the pedal to accelerate the engine speed control lever setting. This pedal stops the machine when fully depressed. It also serves as a parking brake when the brake pedal lock is applied and brake pedal lock knob is pulled. Periodic adjustment of the pedal might be required. Refer to Authorized Distributor of Construction Equipment if pedal values are not within those shown in Fig. 4.11. Fig. 4.11. Brake and Decelerator Pedal Adjustment 1.
Deceleration Angle (10°) 2. Braking Angle (14°) 3. Brake Lock Linkage 4. Brake and Decelerator Pedal 4.6.8. BRAKE AND DECELERATOR PEDAL LOCK This lock secures the brake and decelerator pedal in the applied position for parking the machine. To lock the brake and decelerator pedal fully depress the pedal, pull out the lock and remove your foot from the brake and decelerator pedal. To release the brake, depress the brake and decelerator pedal and push the lock. IMPORTANT: Release the brake pedal lock before moving the machine. The brakes could burn or be damaged if the machine is driven with partially applied brakes. 4.6.9.
ELECTRICAL SYSTEM MASTER SWITCH Turn the key clockwise to connect the battery ground circuit. Turn the key counterclockwise to disconnect the battery ground circuit. IMPORTANT: Keep the switch on while the engine is running. TD-40C DRESSTA