DRESSTA Co. Ltd. TD-40C98/1E — 4.9. DRIVING THE MACHINE

OPERATING SECTION 4 Page 23 STOPPING THE ENGINE 1. Using control lever (1) lower all mounted equipment to the ground. Depress the brake and decelerator pedal (2) and place transmission shift lever (3) into NEUTRAL. 2. Apply transmission neutral lock lever (4). 3. If engine operated under load, operate the engine at idle speed for 3 to 5 minutes to allow the engine to cool down in gradual and uniform manner. 4. Depress and lock brake and decelerator pedal. Fig. 4.18. Engine Speed and Shut Down Control Lever IMPORTANT: Immediate engine shut down after operation under load may result in engine damage. 5.

Shift the engine speed and shut down lever to large notched OFF position – the electrovalve will shut down the engine. ( KTA-19C engine only) 6. QSK-19 engine only: Turn the starting switch key to the left to the OFF position (Fig. 3B). The engine will be shut off. 7. Turn the electrical master switch to the OFF position. 4.9. DRIVING THE MACHINE IMPORTANT: Read the SAFETY PRECAUTIONS in Section 2 before operating the machine. IMPORTANT: Before operating check all instruments. WARNING! Never haul passengers. Only the operator should be on the machine when it is moving. WARNING! Sit in the operator seat before operating the controls.

Keep hands and footwear free of grease, water and mud to insure positive control movements. WARNING! Before operating the machine adjust the seat to allow full access of all controls and fasten the seat belt. Failure to do so could result in serious injuries or death. WARNING! Never get on or off the machine while it is moving because serious injury or death could result. DRESSTA TD-40C