OPERATING SECTION 4 Page 25 4.11. CONVERTER OVERHEATING If the pointer of the torque converter oil temperature gauge moves out of the RUN area of the dial during operation, the transmission may be in a gear range which is too high for the load. Shift down into the next lower gear range. The temperature should reduce; if not, downshift again. If the dial pointer remain out of the RUN range in first gear, stop the machine, shift into neutral and run the engine at 1000 RPM until the gauge pointer moves into the RUN area. If the converter still remains overheated, stop the engine and consult Authorized Distributor of Construction Equipment before operating the machine. 4.12.
STEERING THE MACHINE Fig. 4.21. Steering Levers A – High Range B – Low Range C – Pivot Steering is accomplished with the two steering levers. Each of the two levers function in three positions as shown in Fig. 4.21. in forward position A transmits power to the track in high range in middle position B transmits the power to the track in low range in rearward position C disconnects the power and applies the brake To turn to the right or left pull back the steering lever on the side toward which the turn is to be made. Pull lever back just enough to make the desired turn. To make a pivot turn pull the lever all the way back. To make a gradual left turn proceed as follows:
With steering lever in high range move LH steering in low range. When both steering levers are in low range, move RH steering lever in high range. To make a gradual right turn proceed in similar manner. DRESSTA TD-40C