DRESSTA Co. Ltd. TD-40C98/1E — 5.4. LUBRICATION

MAINTENANCE SECTION 5 Page 11 5.4. LUBRICATION Front idlers, track idlers and track rollers are permanently lubricated with a SAE30, API CD or MIL- L-2104C engine oil. A level check of these compartments is not required. 5.4.2. WHEN SERVICED WARNING! When you service the machine, always follow the Operator's or Service Manual. Never grease, oil or perform any maintenance alone with the engine running. Always have another experienced person helping in the operator's compartment when maintenance must be done with the engine running. Block up all attachments securely. Do not leave the operator's seat with the engine running.

Failure to follow these instructions could result in serious injury or death. The life and performance of a tractor and its equipment depends on the service that it is given. Proper lubrication is an important part of the maintenance service. Thorough lubrication service performed at specified intervals will aid in prolonging the life of the tractor and its equipment and in reducing operating expense. The type of work being done, load, ground and weather conditions are all factors to consider in frequency of lubrication. The scheduled intervals between lubrication periods shown on the “SERVICE CHART” are approximate, based on average operating conditions.

It may be necessary to lubricate after shorter working periods under severe operating conditions such as extremely dusty, low engine temperatures, intermittent operation, excessively heavy loads with high oil temperatures, or when diesel fuel with a high sulfur content is used. However, the time intervals between lubrication periods must never exceed those indicated in this manual. 5.4.3. SELECTION The selection of the proper type (specification) and the grade (weight or viscosity) of lubricant is important. Many tests have been made to determine the correct lubricants for this tractor and its equipment. 5.4.4.

VISCOSITIES During cold weather, base the selection of a crankcase lubricating oil viscosity on the lowest anticipated temperature for the day to make starting easier. For hot weather operation, base the selection on the highest anticipated temperature. Refer to the "REFILL SPECIFICATIONS AND CAPACITIES CHART”. IMPORTANT: After changing oil or break in operation for more that 5 days follow the below specified procedure to start the engine: 1.

QSK–19C – Engine Procedure Disconnect EPS 1) connector of engine electrical system as shown in Engine Manual crank the engine until the gauge registers pressure or engine oil pressure warning light goes off reconnect EPS start the engine per normal method for starting procedure 1) EPS – Engine Position Sensor DRESSTA TD-40C