Komatsu — PARKING BRAKE INSPECTION AND ADJUSTMENT

Maintenance - Section 4 OM4010 05/07 Page 4-24 Lubrication and Service Standard clearance: Total for both clearances = 1.6 ± 0.08 mm. (0.063 ± 0.003 in.) when pushed to one side; or 0.8 mm each for both sides. 5. After adjusting, return capscrew (2) to a position where capscrew retainer (3) stops it from turn- ing. Refer to Shop Manual, Section J, Brake System , for specific disassembly, repair, and replacement procedures for the parking brake assembly. 4. After adjusting the pad clearance, actuating stroke “a” (Figure 4-18) of the rod should be measured and adjusted to approximately 50 mm (1.97 in). (Figure 4-20) FIGURE 4-18. ARM ADJUSTMENT 1. Slack Adjuster 2. Capscrew 3.

Capscrew Retainer 4. 50 mm (1.97 in.) 1. Adjustment Plug 2. Measuring Rod FIGURE 4-19. ADJUSTMENT CLEARANCE 1. Feeler Gauge 2. Adjustment Plug FIGURE 4-20. ADJUSTING CLEARANCE