Operations and Checks After Starting Engine OPERATION Emergency stop: If the operation is abnormal or any other trouble occurs, turn the key in the starting switch to the OFF position. If the work equipment is operated without warming up the machine sufficiently, the response of the work equipment to the movement of the control lever will be slow. The work equipment may not move as the operator desires. Do all warm-up procedures. In cold areas, make sure to warm up the machine properly. Breaking in the Machine Your Komatsu machine has been thoroughly adjusted and tested before shipment.
However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the life of the machine. Be sure to break in the machine for the initial 100 hours (as indicated by the service meter). During breaking-in operations, follow the precautions described in this manual. Idle the engine for five minutes after starting. Avoid operations with heavy loads or at high speeds. Immediately after starting the engine, avoid sudden starts, sudden acceleration, unnecessary sudden stops, and sudden changes in direction. Checks After Starting Engine Check Parking Brake Check that the parking brake works properly.
If there is any abnormality in the operation of the parking brake or the brake does not provide the proper braking effect, contact your Komatsu distributor for adjustment. Check Brake Pedal Set the machine on level ground with no obstacles in the surrounding area. Drive the machine slowly forward and in reverse and check the braking effect of the brakes. If there is any abnormality in the operation of the brakes, ask your Komatsu distributor to carry out adjustments. Check Travel of Brake Pedal Depress the brake pedal fully and check the distance from the floor. Check that the pedal is not too close to the floor and that there is no abnormal feeling when operating the brake pedal.
If any abnormality is found, ask your Komatsu distributor to carry out adjustments. WA500-3LK 2-59