Komatsu — Lift Arm Operation

OPERATION Operation of Work Equipment When standing up from the operator's seat, always set the safety lock lever securely to the LOCK position. If the safety lock lever is not locked and work equipment control lever (A) is touched by mistake, this may lead to a serious accident. If the safety lock lever is not set securely in the LOCK position, the control levers may not be properly locked. The work equipment may move and cause serious personal injury. Check that the lever setting is as shown in the graphic. When pulling the safety lock lever up or pushing it down, be careful not to touch work equipment control lever (A).

Lift arm control lever (1) and bucket control lever (2) can be used to operate the lift arm and bucket. Lift Arm Operation The lift arm control lever is used to operate the lift arm. Set the work equipment lock lever to the FREE position before operating the control lever. Position (a): RAISE Position (b): HOLD The lift arm is kept in the same position. Position (c): LOWER Position (d): FLOAT The lift arm moves freely under external force. When the lift arm control lever is pulled further from the RAISE position, the lever stops at that position until the lift arm reaches the preset kickdown position. At that point, the lever returns to the HOLD position.

Remark Do not use the FLOAT position when lowering the bucket. Use the FLOAT position when leveling; see “Leveling Operations” on page 2-75. 2-70 WA500-3LK