Komatsu — Digging

OPERATION 5. Drive forward at right angles to the rock and change the direction that the machine is facing. 6. Operate the accelerator to match the condition of the road surface so that the tires do not slip. 7. Scoop up the gathered rock. Load hard-cutting rock or boulders in the middle of the bucket. Digging Do not shift down with the accelerator pedal depressed (with the engine speed raised). If the transmission is shifted down when the engine speed is high, there will be an excessive load on the engine, torque converter, transmission, axles, final drive, and the whole power train. When thrusting the bucket in, shift down to 1st.

If the bucket is thrust in at high speed, there will be an impact load on the machine. This will reduce the service life of the machine. When shifting down, release the accelerator pedal to reduce the engine speed before shifting down and then gradually depress the accelerator pedal. If the accelerator is operated suddenly after shifting down, there will be an excessive load placed on the engine and power train. Do not carry out operations with the machine articulated. If the machine is articulated, the direction of force will be different on the front wheels and rear wheels. As a result, the power, when traveling, will not be transmitted fully to the front wheels.

This will reduce the digging force and place an excessive load on the center hinge pin. In addition, even with the front wheels, the power will not be transmitted uniformly to the left and right wheels. The load will be placed on one wheel thus reducing the service life of the tire on one side. Do not push the bucket in too far. If it is pushed in too far, a heavy load will be placed on the machine. This will reduce the service life of the work equipment and frame. Operate the control lever slowly near the end of the bucket tilt operation. If the control lever is operated suddenly, an impact load will be placed on the tilt cylinder. There is danger that the cylinder may be damaged.

When close to a pit excavation, do not let the front wheels rise up on the cutting face. The rocks will cut the tires. 1. Immediately in front of the rock, let the accelerator pedal back and shift down from 2nd to 1st. 2. After shifting down, depress the accelerator pedal gradually and push the rock. 3. Raise the lift arm slightly and increase the driving force of the front wheels. When doing this, do not push the bucket in too far. Remark When digging up large rocks, in some cases it may be better not to raise the lift arm too high. If the lift arm is raised too high, the rear wheels may come off the ground. 2-78 WA500-3LK