OPERATION TRANSPORTATION When transporting the machine, observe all applicable laws and regulations and be careful to assure safety. Transportation Procedure As a general rule, always transport the machine on a trailer. When selecting a trailer and transporting the machine, choose the optimum transportation method in reference to the weight and dimensions shown in “SPECIFICATIONS” on page 4-2. Note that machine specifications (weight and dimensions) vary depending on the kind of tires and bucket. Loading and Unloading Trailers When loading or unloading the machine, run the engine at low speed; travel at low speed; and operate slowly.
When loading or unloading the machine, stop the trailer on firm, level ground. Keep well away from the road shoulder. Use ramps of ample width, length, thickness, and strength. Install them securely at an angle of less than 15°. When using an embankment, compact the fill soil thoroughly and make sure that the slope face does not collapse. Remove the mud stuck to the undercarriage to prevent the machine from slipping to the side on the ramps. Remove any water, snow, ice, grease, or oil from the ramps. Never change direction on the ramps. There is danger that the machine may tip over.
If it is necessary to change direction, return to the ground surface or the trailer platform; correct the direction; and start again. The position of the center of gravity of the machine will change suddenly at the connection of the ramp and trailer. At this point, there is danger of the machine losing its balance. Always drive slowly over the connection point. Loading Machine When loading the machine, always use ramps or a platform. Be sure the loading area is flat and dry. 1. Load on firm, level ground. Maintain a safe distance from the edge of the road. 2. Apply the brakes on the trailer and insert the blocks under the tires to ensure that the trailer does not move. 3.
Fix the ramps in line with the center of the trailer and the machine. Be sure that the two sides are at the same height. Make the angle of the ramps a maximum of 15°. Set the distance between the ramps to match the center of the tires. If the ramps sag a lot, reinforce them with blocks, etc. 4. Determine the direction of the ramps, then slowly drive the machine up the ramps. 5. Load the machine correctly in the specified position on the trailer. 2-102 WA500-3LK