Other Troubleshooting OPERATION Electrical System ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, contact your Komatsu distributor for repairs. * See “Every 250 Hours Service” on page 3-46. WA500-3LK 2-125 Problem Main Causes Remedy Lamp does not glow brightly even when the engine runs at high speed. Lamp flickers while engine is running. • Defective wiring • Defective adjustment of alternator belt tension • (Check, repair loose terminals, disconnections.) • Adjust alternator belt tension. * See EVERY 250 HOURS SERVICE.
Even when the engine is running, the battery charge circuit caution lamp does not go out. • Defective alternator • Defective wiring • (Replace.) • (Check, repair.) Abnormal noise is generated from alternator. • Defective alternator • (Replace.) Starting motor does not turn when starting switch is turned ON. • Defective wiring • Insufficient battery charge • (Check, repair.) • Charge. Pinion of starting motor keeps going in and out. • Insufficient battery charge • Charge. Starting motor turns engine sluggishly. • Insufficient battery charge • Defective starting motor • Charge. • (Replace.) Starting motor disengages before engine starts.
• Defective wiring • Insufficient battery charge • (Check, repair.) • Charge. Engine preheating pilot lamp does not illuminate. • Defective wiring • Defective glow relay, glow controller, water temperature sensor • Defective engine preheating pilot lamp • (Check, repair.) • (Replace.) • (Replace.) Even when engine is stopped, battery charge circuit caution lamp does not illuminate (starting switch at ON position). • Defective wiring • Defective monitor • (Check, repair.) • (Replace.)