Komatsu — Bleeding Air from Hydraulic Circuit

Welding Instructions MAINTENANCE Turn the engine starting switch off; wait for approximately one minute; then disconnect the battery negative (-) terminal. Do not apply more than 200V continuously. Connect grounding cable within 1 m (3.3 ft) of the area to be welded. If the grounding cable is connected near instruments, connectors, etc., the instruments may malfunction. Avoid seals or bearings located between the area to be welded and the grounding point. Do not use the area around the work equipment pins or hydraulic cylinders as the grounding point.

Do Not Drop Things Inside Machine When opening inspection windows or the oil filler port of the tank, be careful not to drop nuts, bolts, or tools inside the machine. If such things are dropped inside the machine, it may cause damage and/or malfunction of the machine and lead to failure. If you drop anything inside the machine, always remove it immediately. Do not put unnecessary things in your pockets. Carry only things which are necessary for inspection. Dusty Work Sites When working at dusty work sites, do the following: Check the air cleaner clogging caution pilot lamp frequently to see if the air cleaner is clogged. Clean the air cleaner element at a shorter interval than specified.

Clean the radiator core frequently to avoid clogging. Clean and replace the fuel filter frequently. Clean electrical components, especially the starting motor and alternator, to avoid an accumulation of dust. When inspecting or changing oil, move the machine to a place that is free of dust to prevent dirt from getting into the oil. Avoid Mixing Oil Never mix different brands or grades of oil. If a different brand or grade of oil has to be added, drain the old oil and replace all the oil with the new brand or grade of oil. Locking Inspection Covers Lock the inspection cover in position securely with the lock bar.

If inspection or maintenance is performed with the inspection cover open and not locked into position, there is a danger that it may be suddenly blown shut by the wind and injure the worker. Bleeding Air from Hydraulic Circuit If the hydraulic oil equipment has been repaired or replaced and if the hydraulic hoses, pipes, etc. have been disconnected, it is necessary to bleed air from the circuit. See “Change Oil in Hydraulic Tank, Replace Hydraulic Tank Filter Element” on page 3-65. WA500-3LK 3-3