Komatsu — Grease

When diluting the antifreeze coolant, use distilled water or tap water (soft water). MAINTENANCE Natural water, such as river water or well water (hard water), contains large amounts of minerals (calcium, magnesium, etc.). This makes it easier for scale to form inside the engine or radiator. Once scale is deposited inside the engine or radiator, it is extremely difficult to remove it. The deposition of scale also causes overheating due to poor heat exchange. When you dilute the coolant, we recommend that you use water with an overall hardness of less than 100 PPM. When using antifreeze, always observe the precautions given in Section 1 of this manual.

See “Cooling System Precautions” on page 1-35 and “Disposal of Waste Materials” on page 1-39. Antifreeze coolant is flammable; be sure to keep it away from flames. The ratio of Supercoolant (AF-NAC) to water differs according to the ambient temperature. For details of the ratio when mixing, see “Clean Inside of Cooling System” on page 3-24. Supercoolant (AF-NAC) may be supplied already mixed. In such cases, never dilute with water. If the engine overheats, wait for the engine to cool before adding coolant. If the coolant level is low, it will cause overheating; it will also cause problems with corrosion due to air entering the coolant.

Grease Grease is used to prevent seizure and noises at the joints. This construction equipment is used under heavy-duty conditions. Always use the recommended grease and follow the change intervals and ambient temperatures given in this manual. Grease fittings not included in the MAINTENANCE section are grease fittings that are used at the time of overhaul; there is no need to grease these points. When using the machine after it has been in storage for a long time, carry out greasing if there is any stiffness or screeching. If any part becomes stiff or makes noise after being used for a long time, apply grease. Always wipe off all of the old grease that is pushed out when greasing.

Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. WA500-3LK 3-7