Komatsu — Removal of ECSS Piping

ELECTRONIC-CONTROLLED SUSPENSION SYSTEM OPTIONS, ATTACHMENTS Electronic-controlled suspension system = ECSS Operating ECSS The ECSS switch (1) is on the left side of the main panel and is used to actuate the electronic-controlled suspension system. Press the ECSS switch to turn on the ECSS. The pilot lamp (2) lights up and the ECSS is actuated. The pilot lamp is orange. Press the switch again to turn off the ECSS. The pilot lamp goes out and the ECSS is canceled. Precautions When Using ECSS Switch If the machine is traveling or the work equipment is raised, the work equipment will move the moment the ECSS switch is turned ON.

The work equipment may move the moment operations are started if the ECSS switch is at the ON position. Keep the ECSS switch turned OFF during operations. Never turn the ECSS switch ON during inspection or maintenance. The work equipment will move and create a dangerous situation. Always stop the machine and lower the work equipment to the ground before operating the ECSS switch. When carrying out inspection and maintenance, first lower the work equipment to the ground, then turn the ECSS switch OFF before starting the inspection and maintenance operation. If the starting switch is at the OFF position, the ECSS will not be actuated even if the ECSS switch is at the ON position.

If the starting switch is at the ON position, it is possible to actuate the ECSS. If the ECSS switch is turned to the ON position, it will switch to the actuated condition. The ECSS will not be actuated if the transmission is in 1st or if the travel speed is less than 5 km/h (3.1 mph). If the transmission is in 2nd to 4th and the travel speed is more than 5 km/h (3.1 mph), the swaying of the chassis is effectively dampened by the accumulator pressure in accordance with the condition of the load. Removal of ECSS Piping Do not remove the piping or parts of the ECSS. If they must be removed, ask your Komatsu distributor to carry out the operation. WA500-3LK 5-5