Adjusting Air-Suspension Seat OPTIONS, ATTACHMENTS Stop the machine in a safe place before adjusting the operator's seat. Adjust the seat position at the beginning of each shift or when operators change. Put your back against the backrest of the operator's seat and adjust the seat so that it is possible to depress the brake fully. (A) Fore-and-aft adjustment Pull lever (1) up; set the seat to the desired position; then release the lever. Fore-and-aft adjustment: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.180 mm (18 mm x 10 stages) (7.09 in [0.71 in x 10 stages]) (B) Adjusting seat angle Move lever (2) up and push down on the rear of the seat to tilt it backward. Move lever (2) down and push down on the front of the seat to tilt it forward. Adjustment range (four stages each): Forward tilt: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13 degrees Rear tilt: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13 degrees (C) Adjusting seat for operator’s weight Sit on the seat and operate valve (3) to adjust the strength of the suspension. Push: suspension becomes stronger. Pull: suspension becomes weaker. Adjustment range (Target): . . . . . . . . .
50 to 120 kg (110 to 265 lb) (D) Adjusting backrest angle Move lever (4) up and move the seat backrest to the front or rear. Push your back against the backrest when carrying out this adjustment. If your back is not pressing against the backrest, the backrest may suddenly spring forward. Adjustment range: Forward tilt: . . . . . . . . . . . . . . 66 degrees (3 degrees x 22 stages) Rear tilt: . . . . . . . . . . . . . . . . . 72 degrees (3 degrees x 24 stages) Remark If the seat back is reclined too far, the seat back may hit the rear glass. Use it in a position where it does not contact the glass. WA500-3LK 5-29