When Not Using the Air Conditioner Regularly OPTIONS, ATTACHMENTS To prevent leakage of the refrigerant from the air conditioner cooling circuit, operate the air conditioner for several minutes two or three times a month during the off-season. If the air conditioner is left for a long time when the refrigerant is leaking, it may cause internal rust. Run the air conditioner in cooling or dehumidification plus heating mode for several minutes from time to time to prevent the loss of the oil film in various parts of the compressor. If the temperature inside the cab is low, the air conditioner may not work.
In such cases, use the recirculated air to warm up the inside of the cab, then turn the air conditioner switch on. The air conditioner will run. Precautions When Using Air Conditioner To prevent any excessive load on the engine or compressor, use the air conditioner only when the engine is running. If the machine is used in places where there is dust or a bad odor, recirculate the air inside the cab when using the air conditioner. Remark If water gets into the control panel, it may lead to unexpected failure. Be careful not to let water get on this part. In addition, never bring any flame near the control panel.
Ventilate from Time to Time when Cooling When turning the cooling on, if the temperature inside the cab is high, open the doors and windows to bring in fresh air before starting the air conditioner. If you smoke when using the cooling, your eyes may sting. If this happens, switch temporarily to cooling and ventilation to remove the smoke. When using the air conditioner for a long time, carry out ventilation and cooling once every hour. Do Not Make Temperature in Cab Too Low For reasons of health, the optimum setting for cooling is considered to be when it feels slightly cool (5 or 6°C (9 or 10.8°F)) lower than the ambient temperature) when you enter the cab.
Do not make the temperature inside the cab too low or direct the air flow directly onto your skin. Be extremely careful to select the appropriate temperature. Inspection and Maintenance To prevent loss of the oil film at various parts of the compressor when the air conditioner is not being used, run the compressor at low speed for several minutes once a week. (Run the engine at low speed and set the temperature to a medium temperature.) For information about cleaning the air filter and inspecting the refrigerant, see “Check Air Conditioner” on page 3-38, “Clean Element in Air Conditioner Fresh Air Filter” on page 3-44, and “Clean Element in Air Conditioner Recirculation Filter” on page 3-50.
To enable the air conditioner to perform to the fullest and maintain a pleasant working environment, always contact your Komatsu distributor to have the air conditioner refilled with refrigerant and carry out other checks. WA500-3LK 5-51