OPTIONS, ATTACHMENTS 3. Stop the machine so that drain plug (4) of the final drive is at the bottom. Remove oil filler plug (5) and drain plug (4), and drain the oil. 4. After draining the oil, clean drain plugs (2), (3), and (4), then install them. 5. Using a filter wrench, turn brake cooling oil filter cartridge (6) on the inside of the frame to the left to remove it. 6. Open engine side cover (7) on the left side of the machine. Using a filter wrench, turn brake cooling oil filter cartridge (8) to the left to remove it. 7. Clean the filter holder, then tighten the new filter cartridge fully by hand. Filter cartridge part No: . . . . . . . . . . . . . . . . . . . . . . 425-S05-2700 Qty: .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 8. Add oil to the specified level through the oil filler ports (1) and (5) of the axle housing and left and right final drives. 9. After adding the oil, check that the oil is at the specified level. For details, see “Check Axle Oil Level, Add Oil” on page 5-53. 5-56 WA500-3LK