RULES FOR ROAD TRAVEL SAFETY Traveling with your machine may pose some hazards. When traveling, always travel in a safe manner and remain alert at all times. A safety-conscious operator is the most important insurance when traveling with the machine. The operator should be aware of the following situations and information. Raise the bucket to a safe travel height (A) of 40 to 50 cm (16 to 20 in) from the ground. If the work equipment is not raised far enough from the ground, there is danger that the work equipment will touch the ground and cause the machine to tip over. Lock the loader control levers using the safety lock. Obey all traffic rules when traveling on local and state roads.
Always travel at a safe, controllable speed. Never turn the key in the starting switch to the OFF position. If the engine stops, apply the brakes and stop the machine immediately. Always be aware of your clearances and road surface. When traveling on rough ground, travel at low speed and do not operate the steering suddenly. When passing over bridges or structures, check first that the structure is strong enough to support the weight of the machine. Avoid traveling over obstacles when possible. Do not travel over obstacles which make the machine tilt strongly to the left or right side.
There is more danger of the machine tipping over to the left or right than tipping over to the front or rear. Plan your route in advance. If necessary, obtain the aid of an escort to lead or prepare your travel route. Never travel at high speeds. Loss of control or tire damage may result. Traveling in Reverse Traveling in reverse may pose several hazards. This is a list of basic rules to follow when traveling in reverse. Always operate the machine only when you are seated. Be sure that the area behind you is clear of people or objects that might be in the way. Before moving your machine, sound the horn to warn others in your area that you are moving.
Check that the backup alarm (alarm buzzer when machine travels in reverse) works properly. When operating in areas that may pose a hazard or where there is poor visibility, designate a person to direct your movements. Do not rely totally on the mirrors on your machine. There are blind spots when using the mirrors. WA500-3LK 1-27