OPERATION These monitors do not guarantee the condition of the machine. Do not rely solely on the monitor when carrying out preoperation checks (daily inspection). Get off the machine and check each item directly. Warning Display (B, E) These consist of the central check lamp (CHECK), central warning lamp (CAUTION), and warning pilot lamps (engine water level, engine oil level, brake oil pressure, engine oil pressure, battery charge, and air cleaner clogging). See “Warning Display” on page 2-8.
Meter Display Portion (A, C, D) These consist of the meters (speedometer, fuel gauge, engine water temperature gauge, torque converter oil temperature gauge, service meter, transmission shift indicator) and the pilot lamps (turn signal indicator, headlamp high beam, preheating, front working lamp, rear working lamp, transmission cutoff, parking brake, transmission auto-shift/manual selector). See “Meter Display Portion” on page 2-13. Option Display Portion (F) This consists of the monitor lamps and switches for the ECSS, auto-greasing system, and remote positioner. For details about each system or component, see “OPTIONS, ATTACHMENTS” on page 5-1.
Testing Actuation of Machine Monitor System When the starting switch is turned to the ON position before starting the engine, all monitor lamps, gauges, and centralized warning lamps light up for approximately three seconds, and the alarm buzzer sounds for approximately one second. When this happens, “88” is displayed on the speedometer and “8” is displayed on the transmission shift indicator. Finally, there are two beeps to indicate that the monitor check has been completed. If the monitor lamps do not light up, there is probably a failure or disconnection. Contact your Komatsu distributor for inspection.
When the starting switch is turned to the ON position and the directional lever is not at the neutral position, the central warning lamp (CAUTION) flashes and the alarm buzzer sounds intermittently. If this happens, return the lever to the neutral position; the lamps will go out and the buzzer will stop. The monitor check cannot be carried out for at least 30 seconds after the engine has been stopped. WA500-3LK 2-7