OPERATION Parking Brake Switch Always apply the parking brake when leaving or parking the machine. Even if the parking brake switch is turned ON, there is danger until the parking brake pilot lamp lights up. Keep the brake pedal depressed. Remark Never use the parking brake switch to apply the brakes when traveling, except in an emergency. Apply the parking brake only after the machine has stopped. If the parking brake has been used as an emergency brake when traveling at high speed (near the maximum speed), contact your Komatsu distributor to have the parking brake checked for any abnormality. The parking brake switch (14) is used to actuate the parking brake. Position (a):
ON - The parking brake is applied and the parking brake pilot lamp lights up. Position (b): OFF - The parking brake is released. Remark If the directional lever is placed in F (FORWARD) or R (REVERSE) with the parking brake applied, the warning lamp flashes and the alarm buzzer sounds. Before starting the engine, turn the parking brake switch to ON, then turn it to OFF. The machine does not start when the directional lever is operated with the parking brake applied. Power Window Switch When closing the window glass, be careful not to get anyone’s hands or head caught. There is danger of serious injury if anyone gets their head or hands caught in the window glass.
Do not continue to operate the switch when the window is fully opened or fully closed. This may cause failure of the power window. The power window switches (15) and (16) can be used when the starting switch is at the ON position. Portion (A) is pressed - the side window goes down. Portion (B) is pressed - the side window goes up. When the window reaches the top or bottom and the window stops moving, release the switch immediately. 2-24 WA500-3LK