. OPERATION DETAILED CONTROLS AND GAUGES FRESH/RECIRC Selector Switch Switch (6) is used to switch the air source between recirculation of the air inside the cab and intake of fresh air from the outside. When switch (6) is pressed, the lamp above the selector switch lights up to show that air is being blown out. During automatic operation, the selection of inside air (RECIRC) and outside air (FRESH) is performed automatically. Display Monitor Monitor (7) displays the status of temperature setting (a), air flow (b), and vents (c). When OFF switch (1) is pressed, the display of temperature setting (a) and air flow (b) goes out, and operation stops.
3 - 51 Auto Swit With switch low vents air source (RECIRC/FRESH) are automatically selecte d according to the set temperature. When auto switch (5) is pressed, the lamp above the auto switch lights up. Press switch (5), then use temperature control switch (3) to set the temperature, and run the air conditioner under automatic control. When the control is switched from automatic operation to When the from automa to manua l operation, it is possible to operate t he to change a ir flow, vents, and air sourc e (RECIRC/FRESH). Whe n manual control is used , lamp above the auto switch goes out. RECIRC Outside air is shut off and only air inside the cab is circulated.
Use this setting to perform rapid cooling of the cab or when outside air is dirt FRESH Outside air is taten into the cab. Use this setting to take in fresh air when performing demisting. RECIRC Outside air is shut off and only air inside the cab is circulated. Use this setting to perform rapid cooling of the cab or when outside air is dirt FRESH Outside air is taten into the cab. Use this setting to take in fresh air when performing demisting.