. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING equipment, travel) in each direction to release the internal pressure. 3 - 82 If the oil filler cap is re moved without releasing t he interna l pressure, oil will spurt out, so tur n the oil filler cap slowly to release the i nternal pressure, then remove it c 1. If work equipme nt is not in the condition shown i n diagra m on the right, start engine, run a t lo w idle , retract the arm and bucket cylinder s, then lower the boom , set bu teet n contact with the ground, and stop the e ngine. 2.
Within 15 seco nds after stoppin g the engine, switch to the ON position, and operate t he contro l levers ( work 3. Open cover (1) on the left side of t he ma chine an d check sight gauge (G). The oil level shoul d be betwe en the H and L marks. NOTICE Do n ot add oil if the lev el is above the H line . This will damag e the hydraulic equipment and cause the oil to spurt