Komatsu — TRAVELING ON SLOPES

. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose it balance and turn over, so avoid such 3 - 123 operations. Itis particularly dangerous to If such operations have to be swing downhill when the bucket is loaded. performed, pile soil to make a platform (A) on the slope so the machine is kept horizontal during operation. Do not travel up or down s machine may turn over. When traveling, raise the buc ket approx. 20 to 30 cm (8 to 12 in ) fro m the ground. Do not travel downhill in rev Never turn on slopes or trav erse. el across slopes.

Always go down to a flat pla longer, but it will ensure safe Always operate or travel in s ce to perform these operations. It may be ty. uch a way that it is possible to stop safely at any time if the machine sli ps or becomes unstable. When traveling uphill, if the s hoes slip or it is impossible to tr avel u phill using only the force of the tra cks, do not use the pulling force of the arm to help the machine travel up hill. There is danger that the machine may turn over. 1. When traveling down st eep hills, use the travel lever and fuel control lever to keep the When traveling down sl equipment in the postur lower the engine speed. travel speed low.

opes of more than 15°, set the work work e shown in the figure on the r ight, and REMARK rocket side down. with the sprocket side up, the track Travel down hills with the sp I f t he machine travels down rack tends to become loose, and that can cause skipping pitches. 2. When traveling up a ste ep hill of more than 15°, set the work equipment to the postur e shown in the diagram on th e rig ht.