. MAINTENANCE MAINTENANCE PROCEDURE WHEN REQUIRED CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING Checking 4 - 19 When using compres sed air, there is danger of d irt flying and causing Always wear protecti ve glasses, dust mask, or o ther protectiv e equipmen When removing the o uter element from the air cle aner body, it is dangerous to pull it out by force. Wh en working in high places or where the foothold is poor, be careful not to fa ll because of the reactio n when pulling out the ou ter element. Replacing t, O-ring assed since installing the element or if air monitor (1) on the monitor panel flashes the element is cleaned, replace the outer ment, and O-ring.
or valve maged or the rubber is markedly deformed. Replacing elemen If one year has p cleaner clogging immediately after monitor (1) on the mo the element is cleaned element, inner ele Replacing evacuat Replace it if it is da maged or the rubber is markedly de formed. NOTICE Do not clean the air clea ner element until the air clea ner clogging monitor on the monitor panel flashes . If the element is cleaned frequently before the clo gging monitor flashes, the air cleaner wil l not be abl e to display its performan ce fully, and the cleaning efficiency will also go d own. leaning operation, more dirt stuck to the element will fall inside the inner element.
In addition, during the c leaning operation, more dirt stuck to the element wil l fall inside the inner elem Cleaning Outer Elem ent 1. Open the engine h 6 hooks (2), then . Open the engine h ood at the front side of th e machine, remove remove cover (3). g the element, do not leave or keep it in direct NOTICE Before and after cleanin sunlight. . Hold the outer ele ment (6), rock it lightly up and down a nd to the l eft and right, and rotat e the element to the left and right to pull it out.