Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE container under drain valves (6) and (7) to catch the then open drain valves (6) and (7) and drain the coolant. When draining the coolant, install the drain hose (kept in the 4 - 26 4. Se coolan toolbox) to drai n valves (6) and (7) a nd be careful not t the coolant spl 5. After d raining the antifreeze solution, cl ose drain valves ( 6) and (7), then fill with clean water. After the rad iator is f illed with water , start and run the en gine at low idling s peed. After the water temper ature rises above 90°C (194°F ), run the e ngine for about 10 mi nutes. (6) and (7) to drain the water. tor with detergent.

n, follow the instructions given with the flushing agent. valve (1) to the OPEN stopper position. ng the corrosion resistor cartridge, see "REPLACE CORROSION ". he water overflows from the water filler. Determine the proportions of h the water and antifreeze mixture table. n the engine for 5 minutes at low idle, then for 5 minutes at high idle. removed.) 6. Stop th e engine a nd open drain valves (6) and (7) to drai 7. After d raining the water, clean the radia tor with detergent When carrying ou t the flushing operatio n, follow the instructions given with the flushing 8. Close drain valve s (6) and (7). 9.

Replac e the corro sion resistor, and turn valve (1) to the O Fo r de e method for replaci TRIDGE (PAGE 4-74) rs (4) and (5). e and tap water until t 10. Install undercove 11. Fill wit h antifreez antifreeze and wa ter in accordance wit h the water and an 12. To remove air in the cooling system, ru (While doing this, leave the radiator cap