. MAINTENANCE MAINTENANCE PROCEDURE and starting motor. 2. Remove 3 bolts (2), then remove cover (3). 4 - 55 4. When installing, tighten until the packing surface contacts the seal surface of the filter h older, then tighten it 3/4 of a turn. If the filter cartridge is tighten ed too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fu el will also leak from the packing , so always tighten the c 5. After completion of the repla cement of fuel filter cartridge (1), Bleed the air as follows: 6. Add fuel to the fuel tank until 7. After replacing filter cartridg e (1), loosen air bleed plug (B) in the filter head (2). 8.
Loosen the knob of priming p ump (3), then pump the knob until no more bubbles come out o f air bleed plug (B). Nm (0.5 to 0.7 kgm , 3.6 to 5.1 lbft) 9. Tighten air bleed plug (B). Tightening torque: 4.9 to 6.9 Push the knob of priming pu Use a genuine Komatsu par mp (3) in and tighten it. t for the fuel filter cartridge. After replacing the filter cartridge, run the engine, and check for any fuel leakage from the filter se Do not run the starting mot seconds. This will put exces sive load on the wiring harnesses CHECK SWING PINION GRE ASE LEVEL, ADD GREASE at the right side of the machine, can holder cover (1) and spare 1. then remove spare grease grease can. 3.
Insert a scale into the greas e and check that the depth of the grease is approx. 60 mm (2. 4 in). Add grease if necessary. Insert the scale (A) in the pos ition shown in the diagram on the right when measuring.