. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING NOTICE an air conditioner, clean the ± 0.4 lbft) 4 - 57 If compressed air, high-pressure water, or steam hits your body directly or dirt is sent flying b y the compressed air, high-pressure wate r, or steam, there is danger of pers onal injury. Always wear protective glasses, dust ma sk, and other protecti ve equipment.
Whe n using compressed air, use from a distance to prevent damage to the fin In particular, with the fuel cooler and af tercooler, blow with compressed air at an angle of 45 ° with the nozzle at a distance of at least 300 mm (11.8 in). Neve r blow the compressed air at right angles to the core. If the fins are damaged, it may ca use coolant leakage o r overheating. O n dusty jobsites, check the fins daily, irrespective of the maintenance interva 1. Open the engine hood and rear machine. 2. Use compressed to blow off mu r f adiator fins, oil cooler fins, fuel ins (3). At the same time, clean On machines equipped with condenser fins (4) also. Steam or water can be used in 3.
Check the rubber hose. Replac f ound to have cracks or to be h Also, check hose clamps for lo Aftercooler hose clamp tighteni 9.81 ± 0.49 Nm (1.0 ± 0.05 kgm