. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING the engine is stopped, and may cause burns. Wait for the 4 - 70 temperature to go down befo When removing the oil filler c ap, turn it slowly to release the int 1. Set the work equipmen t on the hard and flat ground in the maintenanceposture as shown in the figure, then lower it to the ground and stop the eng ine. 2. Remove the cap from oil filler (F) on top of the hydraulic tank, and release the internal pressure. ove cover (1). 3. Loosen 4 bolts, then rem When doing this, the cov er may fly out under the force of spring (2), hold the cover down when removing the bolts.
), valve (3) and strainer (5), take out 4. After removing spring (2 element (4). If there are metal parti cles or foreign material inside st rainer atsu distributor. in flushing oil. 5. Clean the removed parts 6. Install the new element in the place where old element ( 4) was installed. 7. Set valve (3), strainer (5) and spring (2) on top of the ele ment. 8. Set cover (1) in position, push it down by hand, and inst all the cover with the mounting bolts. port (F). he engine according to "STARTING 9. Install the cap of oil filler 10. To bleed the air, start t ENGINE (PAGE 3-94)" minutes. Stop the engine. and run the engine at low idle for 10 11.
REMARK Operate the machine after h alting for more than 5 minutes t o eliminate bubbles in the oil insid 12. Check for oil leakage an